User manual

User Manual SW-81VA-2
COMM-TEC GMBH SIEMENSSTRASSE 14 TELEFON [phone] WWW.COMM-TEC.DE
D-73066 UHINGEN TELEFAX +49(0)7161/3000-333 [e-mail]
7.2 Autoswitching
The active source is routed. Priority is given to source with the lowest number (1, 2,
3, 4,....) if more than one source is activ.
If an input is selected by front panel, IR-Remote or RS-232 during Autoswitching,
this input is switched to the output and the Autoswitching function is interrupted.
7.3 RGB Mute
The output signal is switched off. This function is useful when the image should
not yet be visible on the display.
Note:
Autosequencing, Autoswitching and RGB Mute are mutually exclusive.
Order of priority: RGB Mute -> Autoswitching -> Autosequencing.
Note:
If the CASCADE function is enabled the three auxiliary functions
by dry contacts are disabled.
RGB Mute and Autoswitching can be activated by serial control (RS-232).
pin Function pin Function
1 Tally 1 14 Input 1
2 Tally 2 15 Input 2
3 Tally 3 16 Input 3
4 Tally 4 17 Input 4
5 Tally 5 18 Input 5
6 Tally 6 19 Input 6
7 Tally 7 20 Input 7
8 Tally 8 21 Input 8
9--22Time
10 -- 23 Autoswitching
11 Autosequence 24 +5 VDC
12 RS-232 Rx 25 Ground
13 Mute