User manual

9 of 17
3.6 Installation of the ProFLECT II i
Caution! Important notes and warnings:
During installation, ensure that the fasteners used are of the required strength and the ceiling is of
sufficient load capacity. Non-observance may cause personal injury and damage to property!
Have the installation done by qualified personnel. COMM-TEC takes no responsibility for personal
injury or damage to property caused by incorrect installation.
3.6.1 Measure the mounting location according to the given requirements. If the mounting location has not
been specified during the preceding planning, the projective geometry must be determined first.
3.6.2 Depending on the distance between raw and suspended ceilings, the ProFLECT II i can be mounted
directly to the raw ceiling or be suspended using threaded rods. Channel section rails are of
advantage in order to better align the ProFLECT II i to the exact position.
3.7 Mounting of the ProFLECT II i
For ceiling suspension of the ProFLECT II i, we recommend that you use the supplied mounting plate. If
necessary, this plate can also be used as a drill template.
In the first step, the mounting plate must be fixed to the ceiling (e.g. on channel section rails). Do not tighten
the screws immediately, as otherwise the ProFLECT II i cannot be inserted. Please allow for a minimum
distance of 1 cm between the ceiling and the mounting plate.
With this in mind, the ProFLECT II i can then be inserted into the mounting plate with slightly tilted position,
be fixed with screws (M5) and, if necessary, be aligned. Finally, all screws must be tightened.
(Ceiling mounting plate)
all measures in mm