User manual

8 of 17
3.4 Position of the small mirror
This position must be located together with the projector’s position. Otherwise, the beam can be cut off from
parts of the ProFLECT II i.
There are different methods for adjustment:
a. The 45° angled mirror holder can be moved vertically in the slotted holes. (Figure 1)
b. The small mirror can in addition be mounted in different positions (see figures 3-5) using the supplied
hex bolts (figure 2).
c. The mirror can be moved horizontally in the cross bar and be fixed in other available slotted holes in
order to align mirror and lens.
Angle:
Use the 3 screws for fine adjustment. The target angle should be 45°.
(Figure 1 – height adjustment) (Figure 2 – hex bolts)
(Figure 3 – standard position) (Figure 4 – front position mounting) (Figure 5 – rear position mounting)
3.5 Position of the mirror flap with large mirror
The adjusted angle should also be 45°.
The mirror flap must be tilted down completely in the service position. This position is designed for
installing/uninstalling the projector in combination with the projector tray through the mirror opening.