User manual

8 of 38
4. Setup
n In the main menu, please using the “▼” button on remote control to select the “SETUP”
item, then press the “ENTER” button. You will be presented with the ProPLAY HD
settings screen.
n You can also press the “SETUP” button on remote control to directly open the settings
screen. (If there is file that is being play, please stop first.)
n There are four groups of sub-menu in the main menu (“Network Setup”, “FTP
Setup”, “Video Setup” and “Other Setup”).
n In the settings screen, you can use the “▲ ▼ ▲ ▼” buttons to select an item, and
press the “ENTER” button to confirm the selection.
n Press the “SETUP” button on remote control to save and quit the settings screen.
4.1 Network Setup
n Network with: Select your network connection Disable/ RJ45.
n IP Assigned by DHCP: If you have a DHCP-enabled router, please select “On”, then
the router will automatically assigns an IP address to the ProPLAY HD. If you don’t
have a DHCP –enabled router, select “Off” and type the network information in
“Assign IP Address”.
n Assign IP Address: If the ProPLAY HD is connected to a network without a DHCP
server or you want to use Local FTP Server function, enter the fixed IP address, Mask,
Gateway and DNS for the ProPLAY HD.
PS. Refer to 5.1 for how to enter IP address by remote control.
NOTE: Before setting the IP address, Mask, Gateway and DNS, check the network
information of your PC. Please follow the steps below to get the network information of
your PC.
Step 1: Click on “Start” → “Run” and type in “command”, then press “ENTER”.
The MS-DOS window will appear, type in “ipconfig” and then press “ENTER”
to get the network information.