Instruction manual
36
Using the Main Menu
3 When the DVR restarts, click Yes to
confirm the default resolution.
NOTE: If your system resolution is already
in 10
24 x 768, pressing and holding
the Stop button will not restart the
system.
Adjusting Menu Transparency
You can increase or decrease the
transparency of the on-screen menus.
To adjust the transparency of
on-screen menus:
1 Click the Output ta
b.
2 Drag the T
ransparency slider to adjust
transparency.
3 Cl
ick A
pply to save your settings.
Adding Privacy Zones
A privacy zone allows you to block out
up to 4 portions of each channel with a
black square.
ATTENTION: Areas covered by privacy
zones are not visible in recordings.
To configure a privacy zone:
1 Click the Privacy Zone tab
.
2 In the Channel drop-down
menu, select
the channel you wish to configure.
Privacy Zone
3 Configure the following:
• Channel: Sel
ect the channel you wish to
configure.
• Privacy Zone: Sel
ect ON to enable privacy
zones or OFF to disable privacy zones.
• Area Setup: Sel
ect the Area1~4
checkboxes to enable up to 4 privacy
zones.
4 Click the Setup
butt
on next to Mask Area.
The Privacy Area setup screen opens.
Click and drag to move privacy zones
Click Inside the edge and drag to resize
• Click on a privacy area and drag to change
its location.
• Click on the edge of a privacy area and
drag to r
esize a privacy area.
• Right-click when you are finished to exit.
5 (Optional) Use the drop-downs next to
Cop
y to copy privacy areas to another
channel or all channels. Click the Copy
button to copy privacy areas.
6 Click Apply to
save your settings.
Creating a Custom Split-screen
Display
You can create a custom split-screen
display and re-arrange where channels
are placed.
To re-arrange the split-screen display:
1 Select the Output ta
b.