Instruction manual

10
Basic Setup
2 Adjust the camera stand to ensure that the camera has a satisfactory view of the area you
would like to monitor. Stand configuration depends on the mounting surface you have chosen
(see below for suggested stand configurations).
Table Mount Wall Mount Ceiling Mount
Camera model not be exactly as shown
Connecting HD-SDI Cameras to your DVR
1 Connect the BNC connector on the camera to the RG59 extension cable.
2 Connect the male power connector on the RG59 extension cable to the female power
c
onnector on the camera.
3 Co
nnect the BNC connector on the other end of the RG59 extension cable to one of the
CAM
ERA INPUTS ports on the rear panel of the DVR.
NOTE: Make sure to include some slack on the extension cable at both ends when connecting
the c
amera to the DVR. Strip lines may appear in the image if the cable is too tight.
4 Co
nnect the female power connector on the RG59 extension cable to the power adapter.
5 Plug the camera power adapter to a power outlet.
Camera Connection Diagram
RG59 Extension cable
Female power connector
To Digital Video Recorder:
(8-channel model shown)
Male power connector
BNC
To Camera:
Connecting and Removing BNC Cables
BNC (Bayonet Nut Connector) is a special connector that locks on to the system port and
cannot be accidentally removed.
To connect or remove a BNC connector:
• Push the BNC connector firmly into the BNC port and simultaneously twist the connector
cl
ockwise t
o tighten.
• To remove a BNC connector from a BNC port, push and simultaneously twist the connector
count
er-clockwise to loosen the BNC connector.