User guide
Table Of Contents
- Changes to This Guide
- Contents
- Getting Started with Your SoundPoint® IP 650 Desktop Phone
- Customizing Your SoundPoint® IP 650 Desktop Phone
- Configuring Basic Settings
- Changing the Appearance of Time and Date
- Changing the Display Contrast
- Changing the Backlight Intensity
- Enabling the Headset Memory Mode
- Selecting the Correct Headset for Electronic Hookswitch
- Selecting the Ring Type
- Changing the Language
- Changing the Graphic Display Background
- Muting the Microphone
- Adjusting the Volume
- Managing Call Lists
- Managing Contacts
- Managing Incoming Calls
- System Customizations
- Configuring Basic Settings
- Using the Basic Features of Your SoundPoint® IP 650 Desktop Phone
- Using the Advanced Features of Your SoundPoint® IP 650 Desktop Phone
- Using the SoundPoint® IP Backlit Expansion Module
- Troubleshooting Your SoundPoint® IP 650 Desktop Phone
- Regulatory Notices
- Index
User Guide SoundPoint IP 650 Desktop Phone
3 - 4
To place a call using the headset:
>>
Do one of the following:
— With the optional headset connected, press or the
NewCall soft key to obtain dial tone.
Press .
Dial the desired number using the dial pad.
— With the optional headset connected, dial the desired number using
the dial pad.
Press .
Answering Calls
When you are not in another call, you can answer a call in three ways:
• Using the handset
• Using the speakerphone
• Using the headset
The steps for answering an incoming call when you are in another call are
different if your phone is configured for:
• A single Line Key per line
Note
To permanently enable your headset, refer to Enabling the Headset Memory Mode
on page 2-6.