System information

89
Chapter 10: Known Issues
The following table lists known issues for this release. If a workaround is available, it is noted in the
table.
Table 10-1: Feature Limitations
Issue ID Found in Release Description Workaround
SI-84
RMX V7.2
If an RMX system is reset while there is an active
conference, the conference with its SIP participants
is not released.
Reset the RMX
system after
terminating all
active conferences.
SI-97
RMX 7.7
The recording link cannot be configured if the RMX
system is set up with network separation.
None
SI-136
VVX 3.3.1 HDX 3.0.3
The VVX 1500 connects to the HDX with asymetric
codec negotiation (H.263 sending/H.264 receiving).
None
SI-157
HDX 3.0.3
When touch control is connected to HDX, the HDX
sends DTMF inband.
None
SI-162
SSIP 3.3.1
On the IP 7000, you cannot make calls from the
missed calls list.
None
SI-165
HDX 3.0.5
HDX disabled BFCP after re-invite when used as
preferred device and HDX is set to manual answer.
Use Auto-Answer
mode.
The 3.0.5 hotfix will
be available via
Polycom global
support to address
this issue.
SI-173
VVX 4.0.2B
A TLS problem exists between OpenScape Voice and
the VVX 1500.
Use TCP or UDP
SI-192
OpenScape V6R0
The HDX and VVX phones disconnect after being put
on hold by OpenStage phones during a secured call.
Use TCP or UDP
SI-195
OpenStage V3
Dial-out calls to a Siemens OpenStage phone from
the RMX do not connect if TLS and SRTP are
enabled.
Use Dial-in scenario
or connect the
OpenStage phones
via TCP or UDP