System information

Integrating Polycom RMX Systems with Siemens OpenScape

Using IPv6 Network Addresses for RMX Internal and

External Entities

Not all IPv6 settings are available. You can assign the following IPv6 addresses to RMX (Internal) and

External Entity addresses.

RMX Internal Addresses

Default Management Network Service

• Control Unit

• Signaling Host

• Shelf Management

• MPM1 (Media Card)

• MPM2 (Media Card)

External Entities

• Gatekeepers (Primary & Secondary)

• SIP Proxies

• DNS Servers

• Default Router

• Defined participants

IPv6 Guidelines

The following is a list of guidelines when using IPv6:

• You must use Internet Explorer 7 to connect the RMX Web Client and RMX Manager to the RMX

system using IPv6.

• IPv6 is supported with MPM+ and MPMx media cards only.

• The default IP address version is IPv4.

• You can define the IP address field in the address book entry for a defined participant as either

IPv4 or IPv6. You cannot add a participant with an IPv4 address to an ongoing conference while

the RMX system is in IPv6 mode nor can you add a participant with an IPv6 address while the RMX

system is in IPv4 mode.

• Participants that do not use the same IP address version as the RMX system in ongoing

conferences launched from Meeting Rooms, Reservations and Conference Templates are

disconnected. An error message, Bad IP address version, is displayed.

• IP Security (IPSec) Protocols are not supported.