System information

Integrating Polycom RMX Systems with Siemens OpenScape
55
○ Signaling Host IP Address Enter the address you want IP endpoints to use when dialing in to
the MCU. Dial out calls from the RMX system are initiated from this address. This address is
used to register the RMX system with a Gatekeeper or a SIP Proxy server.
○ Media Card 1 Port 1 IP Address and Media Card 1 Port 2 IP Address (RMX 4000) If only one
network is connected to this media card, it is enough to assign one media card to this Network
Service. In such a case, enter one IP address for the media card according to the LAN Port used
for the connection.
If each of the LAN ports on one media card is used with two different networks, each port is
assigned to its own Network Service. In such a case, enter the IP address of the port to be
assigned to this Network Service.
A LAN port that is already assigned to a different Network Service, displays the IP Address of
the assigned port and it cannot be assigned to this Network Service (it is disabled).
○ Media Card 2 Port 1 IP Address (RMX 2000/4000) and Media Card 2 Port 2 IP Address (RMX
4000) Enter the IP address(es) of the media card(s) as provided by the network administrator:
○ RMX1500: MPMx 1
○ RMX 2000: MPM+/MPMx 1 and MPM+/MPMx 2 (if installed)
○ RMX 4000: MPM+/MPMx 1, MPM+/MPMx 2 (if installed), MPM+/MPMx 32 (if installed) and
MPM+/MPMx 4 (if installed)
The media card uses these addresses to connect to conferences and transmit call media, including
video, voice, and content.
○ Subnet Mask Enter the subnet mask of the MCU. The default value is 255.255.255.0.
Configuring RMX Routers
This section shows you how to configure router settings for the RMX.
To configure router settings:
1 In the RMX Management pane, click Routers.
The Routers settings display, shown next.
With the exception of IP Network Type, the field definitions of the Routers tab are the same those
shown in Network Service.