Vimo S-MI 2.
Foreword Thanks for purchasing Comica 2.4G Dual-channel Mini Wireless Microphone Vimo S-MI.
Notice Due to 2.4G wireless characteristics, please keep face to face when use it, and don’t turn your back to the receiver, otherwise it is easy to generate breakpoints, which is a normal phenomenon. Due to the characteristics of lithium batteries, the transmitter's charging indicator will show an inaccurate battery level when the charging starts, and the actual power may be lower than the indicated power. If the transmitter runs out of power, it will take more than two hours to get fully charged.
Packing List Vimo S-MI Versatile 2.
Components and Instruction Transmitter (TX): ① ③ ④ ② ⑤ ① Internal Mic ② Working Status Indicator: Blink blue slowly when unpaired; Blink rapidly when pairing; Show blue when paired; Show green when denoise is on; Show red when muting. ③ Belt Clip ④ Mute/Denoise/Pairing Switch Button: Short press for muting; Long press for pairing when unpaired; Long press for denoise when paired.
Receiver (RX): ③ ④ ② ① ⑤ ⑥ ① Charging/Monitoring Port ② Lightning Plug ③ Transmitter Volume Control Knob: Adjust the volume of transmitter 1/2 synchronously. Turn counterclockwise to increase the volume, and turn clockwise to reduce the volume. ④ Transmitter 1/2 Pairing Indicator: Blink blue when unpaired; Show blue when paired. ⑤ Mode Indicator: Show blue when in mono mode; Indicator is off when in stereo mode. ⑥ Mono/Stereo Switch Button: Short press to switch Mono/Stereo mode.
Charging Case: ③ ④ ① ② ④ ⑤ ⑥ ⑦ ⑧ ① Lightning Port ② Battery Level Indicator Button: Short press to show the battery level of charging case and transmitters. ③ Charging Case Battery Level: 0-100 ④ Battery Level Indicator of Transmitters: The left indicators show the battery level of the transmitter placed in the charger well 1; The right indicators show the battery level of the transmitter placed in the charger well 2. There are four power indicator lights, one of which represents 25% of the power.
Installation and Usage Pairing (All have been paired at the factory. If you need to re-pair, please follow the steps below.) Long press the pairing button on the TX to pair. The indicator lights on the TX and the RX will show blue when the pairing is successful.
Usage 1.
2. Install the transmitter on the collar ① ② Install the transmitter on the collar so that the internal mic points to the sound source 3.
4. Monitoring/Charging Method One Connect USB-C headphones to monitor or connect the power bank/DC power using the USB C-USB A charging cable to charge the mobile phone.
Method Two Connect 3.5mm headphones through the 2 in1 charging/monitoring adapter cable for monitoring and connect the power bank/DC power to charge the mobile phone at the same time.
Specification Wireless Type 2.4GHz Antenna Built-in Antenna Sampling Rate 48kHz Bit Depth 24bits Transmitting Power 10dBm Sensitivity -32dB ±2dB Polar Pattern Omnidirectional Frequency Response 80Hz~20kHz S/N 70dB Equivalent Noise 24dBA Maximum SPL 110dB Dynamic Range 86dB Sound Delay <20ms Battery Charging Time Standby Time TX: Built-in Li-ion Battery 95mAh 3.8V Charging Case: Built-in Li-ion Battery 800mAh 3.
Email: support@comica-audio.
