User Manual

DAW Software Setting

1. Please download and install the driver ASIO4ALL in advance;

2. Connect AD5 to the computer, open Cubase, and create a new project;

3. Click ‘Devices - Device Setup’;

4. Select ‘VST Audio System - ASIO4ALL v2’;

5. Click ‘ASIO4ALL v2 - Control Panel’ to activate the ‘Comica_AD5-USB2’ input/output port (click to lighten the power and play icons);

6. Add a new audio track in the Cubase, click the ‘Record’ icon to start recording, and click the ‘Monitor’ icon to achieve input monitor.

1. Please download and install the driver ASIO4ALL in advance;

2. Connect AD5 to the computer, open ProTools, and create a new project;

3. Click ‘Setup- Playback Engine’, and choose ‘ASIO4ALL v2’;

4. Click ‘Setup - Hardware - ASIO4ALL v2 -Launch Setup App’ to activate the ‘Comica_AD5-USB2’ input/output port (click to lighten the power and play

icons);

5. Add a new audio track using key combo ‘Ctrl+Shift+N’;

6. Click the ‘Record’ icon to start recording, and click the ‘Monitor’ icon to achieve input monitor.

Users can start using the AD5 with the DAW software. (please refer to the following instructions in Cubase and ProTools).

If ‘Comica_AD5-USB2’ cannot be found on the software, please make sure that AD5 is connected to the computer and open the

sound settings in the computer to see if AD5 has been set as the default output device of the computer.

When direct monitoring mode is on, please turn oﬀ the "Monitor" of the DAW software, otherwise you will hear both the audio signal you're

monitoring and the echo eﬀect the signal coming back from the DAW software; when input monitoring mode is on, please turn on the

"Monitor" of the DAW software, in which case users can hear the audios edited by the DAW software.

Cubase

ProTools