CVM-AX3 XLR/6.35mm/3.
Foreword Thanks for purchasing COMICA CVM-AX3 XLR/6.35mm/3.5mm(2-Groups) Amplifier Audio Mixer. The Comica CVM-AX3 is a 3.5mm Dual-Groups Audio Mixer for shooting videos with any camera and camcorder . It is designed with support positive & passive mic, real-time monitoring, dual gain-control knobs functions etc. It provides a compact audio mixing solution. Please read this manual carefully before using.
Package Contents 1 2 3 4 5 Audio Mixer 3.5mm Audio Output Cable Cold Shoe Mount User Manual Warranty Card 1 2 XL R/3.5 CV mm M /6.
Components and Instruction Audio Mixer 1 2 3 4 5 6 7 8 9 10 11 12 13 14 2 Cold Shoe Interface INPUT1 6.35mm Audio Input Jack(Right) INPUT1 XLR Audio Input Jack (Right) INPUT1 6.35mm Audio Input Jack(Left) INPUT1 XLR Audio Input Jack(Left) Locking Plate 1/4 Screw Bolt 3.5mm INPUT2 Mono Input Jack(Right) 3.5mm INPUT2 Stereo Audio Input Jack 3.
Function Switch Guide and Notice 1.INPUT1 For Microphone that’s designed with XLR and 6.35mm Audio Output XLR Audio Input Jack 6.35mm Audio Input Jack INPUT1 XLR and 6.35mm are in the same jack and cannot be used at the same time 2.INPUT2 For Microphone that’s designed with 3.5mm Audio Output Stereo Right 3.5mm Mono Audio Input Left 3.5mm Mono Audio Input INPUT2 Mono and stereo input cannot be used at the same time.
3.LINE/MIC/PH (For INPUT1) If you’re using LINE IN function, set the switch to ‘LINE’ If you work in Non-Phantom Power Mode, set the switch to ‘MIC’ If you work in Phantom Power Opened Mode, set the switch to ‘PH’ Right LINE/MIC/PH Left LINE/MIC/PH 4.
5.LINE/MIC/3V (For INPUT2) If you’re using LINE IN function, set the switch to ‘LINE’ If you’re using Positive Microphone (Mic with power driven), set the switch to ‘MIC’ If you’re using Passive Microphone (Mic with no power driven) , set the switch to ‘3V’ Right LINE/MIC/3V Left LINE/MIC/3V 6.
7.L/R The Gain Control Button L/R is for adjusting sensitivity of Microphones (Corresponding with INPUT 1 & INPUT2 LEFT/RIGTH ) L 8.OUT 3.5mm audio output R OUT 9.
. For Audio Monitoring 11.M/S M is for mono mode ; S is for Stereo mode M/S If there’s only one group microphone connected with this device, then you have to set the M/S to M mode 12.
Installation and Usage Installation method one: 1.Connect the camera to the 1/4 double-screw bolt of the mixer through the 1/4 screw hole 2.
Second methods of installation: 1. Mount the cold shoe mount to the audio mixer 2.
3.
4.
5.
For stereo mic, connect it to the stereo input jack ('S') For mono mic, connect it to the corresponding 'L' / 'R' input jack 6.Set Mono/Stereo switch Mono/Stereo switch a. When uses only one mic or one channel, select ‘M’ and the output is mono b.
7. To ensure the recording quality, please turn Gain-Control Knob of the left and right to the proper volume position to get the best audio effect Left Gain-Control Knob Right Gain-Control Knob 8.
9.
Tech Parameters Input XLR x 2(L/R), 6.35mm x 2(L/R), Mono x 2(L/R), Stereo x 1(S), AUX Output 3.5mm audio output, 3.5mm headphone output Frequency Response 20Hz~20kHz, ±1dB THD+Noise <0.02%, RL=2kΩ, f=20Hz~20kHz, Vo=1Vrms Battery 9V 6LR61/6F22 x 1 Size 123 x 71 x 60.
CVM-AX3 XLR/6.35mm/3.
前 言 感谢您购买科唛XLR/6.35mm/3.5mm音频输入混合型混音器。 此产品可搭配相机、摄像机进行音频录制。它设计有支持主动/被动式麦克风、实 时监听、双音量调节、单/双声道转换、工作状态指示灯、9V电池供电、多冷靴接 口等功能，全铝合金材质制作，功能十分强大，能带给您更好的音质效果。 使用前请认真阅读此使用说明书，本产品在出厂时已进行精密校准，请勿自行组 装拆卸零部件，否则不予保修！ 产品主要功能 .双卡侬头/6.35mm/3.5mm麦克风音频合三为一 .实时监听 .支持主动式/被动式麦克风 .双音量调节旋钮 .单声道/立体声音频输出 .状态指示灯设计 .9V电池供电/幻象电源输出 .外延接口&热靴接口设计 .
包装清单 1 2 3 4 5 混音器 3.5mm音频输出线 冷靴座 说明书 保修卡 1 2 3.5m m/XL CV R/6.
部件介绍及说明 混音器主体 1 冷靴接口 INPUT1 6.35mm音频输入孔（右） INPUT1 卡侬头音频输入孔（右） INPUT1 6.35mm音频输入孔（左） INPUT1 卡侬头音频输入孔（左） 锁盘 1/4螺柱 INPUT2 3.5mm音频输入孔（右） INPUT2 3.5mm立体声音频输入孔 2 3 4 5 6 7 8 9 2 3 4 5 6 10 11 12 13 14 15 16 17 18 INPUT2 3.
按键释义及注意事项 1.INPUT1 用于XLR和6.35mm 接口的麦克风 卡侬头音频输入孔 6.35mm音频输入孔 INPUT1 XLR与6.35mm同在一个座子上，因此不能同时使用 2.INPUT2 用于3.
3.LINE/MIC/PH （对应INPUT1） 如使用LINE IN 输入，将开关拨至’LINE’ 如在非幻象电模式下使用，将开关拨至‘MIC’ 如在幻象电打开的模式下使用，将开关拨至‘PH’ 右声道LINE/MIC/PH 左声道LINE/MIC/PH 4.
5.LINE/MIC/3V （对应INPUT2) 如使用LINE IN 输入，将开关拨至’LINE’ 如使用主动麦克风（麦克风内部有电池供电），将开关拨至’MIC’ 如使用被动麦克风（麦克风内部无电池供电），将开关拨至’3V’ 右LINE/MIC/3V 左LINE/MIC/3V 6.
7.L/R 音量调节旋钮左/右 ，分别针对INPUT 1, INPUT2 的麦克风（左/右） 音量（灵敏度）进行大小调节 L R 8.OUT 3.5mm 音频输出接口 OUT 9.
10. 监听 11.M/S M为单声道模式； S为立体声模式 M/S 当只接入一路麦克风时，只能在单声道模式下进行工作 12.
安装与使用 安装方法一： 1.把相机通过1/4螺孔连接到混音器1/4螺柱上 2.
安装方法二： 1.将冷靴座安装至混音器 2.
3.用3.
4.
5.
若是立体声麦克风，接入“S”立体声输入孔 若是单声道麦克风，接入对应的“L”、“R”输入孔 6.设置单声道/立体声（M/S）开关 单声道/立体声（M/S）开关 14 a. 若使用单只麦克风或一个声道进行录音时，请将开关拨动至‘M’单声道 模式，此状态下只支持M单声道输出； b.
7.为保证录音质量，请将左右声道的两个音量控制旋钮调至合适大小, 以获得最佳音频效果 左音量控制旋钮 右音量控制旋钮 8.
9.如果您想随时检测音频质量，可以将耳机插入混音器监听孔进行监听 监听孔 技术参数 输入 XLR x 2(L/R), 6.35mm x 2(L/R), 单声道 x 2(L/R), 立体声 x 1(S), AUX 16 输出 3.5mm音频输出，3.5mm耳机输出 频响 20Hz~20kHz, ±1dB 总谐波失真+噪声 <0.02%, RL=2kΩ, f=20Hz~20kHz, Vo=1Vrms 电池 9V 6LR61/6F22 x 1 尺寸 123 x 71 x 60.
Email: support@comica-audio.
