Owner`s manual

3
17. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
18. Use only for intended household use as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons.
The use of attachments not recommended or sold by unauthorized dealers may cause
hazards.
19. Always use on a dry, level surface. Use on floor only.
20. DO NOT use outdoors.
21. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any
solid-state speed control device.
22. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
Doing so will void your warranty. The inside of the unit contains no user serviceable
parts. Qualified personnel should perform all servicing only.
23. Connect to properly grounded outlets only.
24. PET OWNERS NOTE: The health of birds and some small pets are extremely sensitive
to the fumes given off during the initial use of many appliances. Although these fumes
are not harmful to humans, it is recommended that this heater not be used around birds
and small pets during its initial use until the manufacturing corrosion coatings burn off.
25. Save these instructions.
SPECIFICATIONS
Voltage Rating
120 V (60Hz)
Power Consumption
1500W, 12.5A
Unit Size
13.1 in. (W) x 16.4 in. (D) x 17.8 in. (H)
Unit Weight
31.75 lbs
SAFETY FEATURES
Tip-Over Safety Feature
This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal
switch will automatically shut the heater off. Once the heater is restored an upright position, the
heater will reset. To continue operation, turn on the heater using the supplied remote control or
the control panel on the heater.
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heaters internal components
reach a certain temperature that could cause overheat and possible fire, the heater will
automatically shut off. To reset, turn heater off and switch master power switch on the rear of
the unit to off position. Unplug the heater and let it cool down for around 20 minutes. Plug the
heater back into the wall outlet and turn master switch and on/off switch to on.