User`s manual

15
Recommended procedure for re-attaching a
section to the keyboard base
1. In one hand, hang the individual section upside
down, with the straight arm of the Disc Loc facing
you.
2. Turn the round metal plate with the two flat edges
counterclockwise until it stops.
3. Hold the Disc Lock in your hand as follows: Your
thumb should be on the topside of the plastic disc
(which is now facing down); your fingers should be
on the bottom side of the round metal plate with the
two flat edges (now facing up).
4. Depress the round center button with the middle
finger. (Make sure the middle finger is parallel to
the flat edges of the round metal plate—see photo).
5. Now rotate the section right side up.
6. Insert the round metal plate with the two flat edges
into the track on the keyboard base. Making sure
that the flat edges line up with the flat edges of the
track.