Installation manual

www.desatech.com
901265-01S18

 
 
 

 -

 
IMPORTANT: Operating log set where impurities in air exist may create odors. Cleaning sup-
plies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc.,
create fumes. These fumes may mix with combustion air and create odors. These odors will
disappear over time.
POSSIBLE CAUSE
1. Metal expanding while heat-
ing or contracting while
cooling
1. Log Set burning vapors
from paint, hair spray,
glues, cleaners, chemi-
cals, new carpet, etc. (See
IMPORTANT statement
above)
2. Gas leak. See Warning

1. Gas leak. See Warning

2. Control valve defective
1. Gas leak. See Warn-
    
page
OBSERVED PROBLEM
Log Set produces a clicking/
ticking noise just after burner
is lit or shut off
Log Set produces unwanted
odors
Gas odor even when control
knob is in OFF position
Gas odor during combustion
REMEDY
1. This is normal with most log
sets. If noise is excessive,
contact qualified service
person
1. Open flue to maximum.
Stop using odor causing
products while log set is
running
2. Locate and correct all leaks
(see Checking Gas Con-
nections, page 8)
1. Locate and correct all leaks
(see Checking Gas Con-
nections, page 8)
2. Replace control valve
1. Locate and correct all leaks
(see Checking Gas Con-
nections, page 8)
TROUBLESHOOTING
Continued