Installation manual

www.fmiproducts.com
125685-01B 23
SMART THERMOSTAT
The Smart Thermostat adjusts ame height
in accordance to differences between set
temperature and room temperature. As room
temperature gets closer to set temperature the
smart function will modulate the ame lower.
As room temperature cools, it will modulate
the ame higher.
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the replace on or off to maintain se-
lected temperature.
SMART
MAX
Figure 34 - Smart Thermostat Setting
ON
Figure 35 - Child Safety Lock-Out
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar-
row button at the same time. To deactivate,
press again.
REPLACING HAND-HELD REMOTE
CONTROL ONLY
If your remote ever needs to be replaced you
will not need to replace the receiver.
PROGRAM RECEIVER TO REMOTE
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG. The
receiver will beep 3 times to indicate it is ready
to accept a new remote transmitter. Press
the ON/OFF button on your remote and the
receiver will beep 4 times to conrm it receives
commands from the new remote.
ON REMOTE OFF
PRG
To
Program
Receiver
Figure 36 - Programing Remote Control
to Receiver
OPERATION
Continued