Installation manual

www.fmiproducts.com
125685-01B18
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
Installing Logs
1. Place bottom log in center of the base as-
sembly as shown in Figure 21.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 21.
Make sure log is completely vertical and
not leaning in toward burner where ame
will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 21).
4. Position front left log against left side of
grate prongs (see Figure 21).
INSTALLATION
Continued
5. Place middle right log over front right and
bottom logs as shown in Figure 22. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 22. Be
sure hole in middle left log seats over pin
in front left log.
Rear Log
Grate
Prongs
Figure 21 - Installing Log Set
Bottom Log
Base Assembly
Front
Right Log
Front Left
Log
Figure 22 - Installing Log Sets
Middle Right Log
Middle
Left Log
Bottom
Log
Pin on Front
Left Log
Figure 23 - Correct Log Placement