Installation manual

www.desatech.com
111161-01K22

Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 33).
To Lock press both buttons on hand-held
remote control until light stops ashing. Hand-
held remote control is now locked. If the re
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together
on hand-held remote control until the light
stops ashing. The hand-held remote is now
unlocked.
ON
OFF
REMOTE
O
F
F
P
I
L
O
T
L
O
I
H
O
N
Figure 32 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Selector Switch in Remote Position
Control
Knob
Flame Adjustment
Knob
Figure 33 - On/Off Hand-Held Remote
Control Unit (HRC101)
THERMOSTAT SERIES (MODEL

The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 34). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Figure 34 - Thermostat Hand-Held
Remote Control Unit (HRC201)
Locks
System to
Prevent
Accidental
Ignition
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns Hand-
Held Remote
On or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO Mode
°C/°F Mode
Button
Turns
Burners
On or Off
Increases or
Decreases
Room
Temperature in
AUTO Mode
Digital
Display
Shows
Temperature
and Settings
Control
Button
Indicator
Light
OPERATION
Continued
MANUAL LIGHTING

1. Follow steps 1 through 6 under Lighting
Instructions, page 21.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
Lighting Instructions, page 21.


Note: Hand-held remote control accessories
must be purchased separately (see Acces-
sories, page 34). Follow instructions included
with the remote control.

-
Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON position.
Adjust ame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 32).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.