Installation manual

www.desatech.com
111161-01K 17
INSTALLING WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
INSTALLATION
Continued
Front
Back
Figure 19 - Installing Remote Receiver
Remote
Receiver
Screws
Valve
White Wire From
Receiver
Figure 20 - Connecting Wires
Red Wire
From
Receiver
Figure 21 - Installing Receiver on Back
of Base
Battery
Clip
9-Volt
Battery
Receiver
Terminal
Wires

1. Locate back of receiver under front burner
of heater.
2. Locate battery clip mounted on back of
receiver.
3. Slide a 9-volt battery through clip.
4. Attach terminal wires to battery.
Battery
Cover
9-Volt
Battery
Terminal
Wires
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit
Remote
Control Unit
Battery
Housing
4. Install remote receiver unit onto gas log
heater base using Phillips head screws
(see Figure 19).
5. Connect wires as shown in Figure 20.

Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to battery. Place
battery into battery housing.
3. Replace battery cover onto remote control
unit.