User manual

5
Micro Receiver DT20
Check the hearing instrument’s input
To be able to use the Micro Receiver DT20, check if — and how — the hearing
instrument supports the use of a mini receiver:
1. The hearing instrument must be equipped with an audio shoe with a
powered Europlug socket made for mini receiver use. This connects the
Micro Receiver DT20 to the hearing instrument and also supplies the DT20
with power from the hearing instrument’s battery. The received audio signal
will then be transferred from the Micro Receiver DT20 to the hearing instru-
ment through the audio shoe.
2a. If the hearing instrument is equipped with a Programmable DAI input
(DPAI), programming of the hearing instrument might be necessary (check
with audiologist or hearing instrument manufacturer). In this case the push-
button on the Micro Receiver DT20 cannot switch between the R and R+M
modes. This is instead done by using different listening programs in the hear-
ing instrument.
TIP! The volume of the Micro Receiver DT20’s R and R+M mode can be set individu-
ally by using the Programmer DT20.
This makes it possible to use the push-button as a simple volume control in
combination with a hearing instrument with Programmable DAI input (DPAI).
EuroplugDT20