User manual

8
Programmer DT05
If you enable
Always on
and at the same time disable
Pairing
, the push-
button on the Receiver DT10 becomes inoperable.
Always on
The setting
Always on
, disables the off-function of the push-button, leaving
the Receiver DT10 always on. Receiver DT10 is turned off when turning off the
hearing aid.
Send all
To configure a Receiver DT10 with all settings in the display of the Program-
mer DT05 select
Send all.
If you choose
Send all,
you will receive the warning
All settings in DT10 will be overwritten”. Only select
Yes
if you want to over-
write all data in your Receiver DT10.
Settings
HA scanner
The HA scanner is used for detecting how much interference there is
from a hearing aid, within the frequency band that the Receiver DT10 is
operating in.
Language
For selection of menu language.
Factory Reset
DT05: Resets the Programmer DT05 to its default settings.
DT10: Resets the Receiver DT10 to its default settings, which means
that also all pairing information is deleted. Receiver DT10 must be set
into pairing mode in order to be reset to default settings.
To prevent eaves-dropping a new code key must be generated.
About
Software information.
6. Remove the paired DT10 and connect the other DT10
into the Programmer DT05.
7. Activate pairing mode on the DT10 by pressing the push-button for
2 seconds.
In the headphones/neckloop you receive an acoustic indication:
8. Open the menu on the DM80 and select
Communication/Pairing/Send
info
.
9. The Receiver DT10 confirms successful
pairing with an acoustic indication:
• •