User manual

7
Programmer DT05
Pairing
When
Pairing
is selected, the DT10 can be set to pairing mode by pressing the
push-button for two seconds.
If
Pairing
isn’t selected, pairing mode cannot be enabled with the push-
button. To override this, (if the Receiver DT10 needs to be reconfigured or
if new pairing information needs to be received), press and hold the push-
button on the Receiver DT10 for 2 seconds within 10 seconds of it having been
connected to a hearing instrument or a Programmer DT05. This sets the
Receiver DT10 to Pairing mode and it is then ready to receive new settings
from the Programmer DT05.
Receiver DT10 can receive but not send pairing information. In order to be
able to pair a Receiver DT10 with a Comfort Digisystem transmitter the
Receiver DT10 must be connected to the hearing aid or to the Programmer
DT05.
Warning! If the Receiver DT10 is in sleep mode and another radio signal
(with the same frequency that you are using) is present, the Receiver
DT10 might start again automatically. This could cause a loud hissing
noise and thats why
Auto sleep
should be used with caution.
Example: Make a new eavesdrop secure configuration with one Microphone
DM80 and two Receiver DT10s using the Programmer DT05:
1. Put one of the Receiver DT10s into the Programmer DT05.
2. Start the Programmer DT05 and connect headphones or a neck loop to
be able to listen.
3. Activate pairing mode for the DT10 by pressing the push-button for
2 seconds.
In the headphones/neckloop you receive an acoustic indication:
4. Start the Microphone DM80 and open the menu. Select
Communication/
Pairing/New code key
and answer
Yes
to the question of whether you
want to create a new code key and transmit it.
5. The Receiver DT10 confirms
successful pairing with an acoustic indication:
• •