User manual

5
Programmer DT05
Programmer DT05
The Programmer DT05 is an optional professional tool that can be used both
for configuring and test-listening of the DT10.
The Programmer DT05 can be used to configure one setting at a time in the
Receiver DT10. Select the desired setting in the menu and double press the
pairing button. The Receiver DT10 must be set to pairing mode.
The Programmer DT05 can also be used to configure all settings at the same
time in a DT10. To do this, adjust all parameters in the DT05 and then select
Send all
on the DT05 menu. The Receiver DT10 must be set to pairing mode.
Receiver DT10 can be configured while connected to the hearing aid. The
distance between the Programmer DT05 and the Receiver DT10 should not
exceed 0.5 meters.
To listen to a DT10, plug it into the socket on the programmer and connect
headphones or a neck-loop.
Menu control
To access the menu, press the menu control
and then scroll up or down.
Press the menu control to select.
Scroll up
Press / select
Scroll down