Remote Control Manual

ManualsBrandsComfort-Aire ManualsComfort Aire Mini-Split Systems9,000 BTU SVH Series Single Zone Ductless Mini-Split AC/Heat Pump Package, 115V

Remote Control Manual - SVH 09/12/18/24 Series

The following cases signify exhausted batteries.

Replace old batteries with new ones.

Receiving beep is not emitted when a signal

is transmitted.

Indicator fades away.

The remote controller is powered by two dry

batteries (R03/LR03X2) housed in the back rear

part and protected by a cover.

(1) Remove the cover in the rear part of the

remote controller.

(2) Remove the old batteries and insert the new

batteries,placing the(+) and (-) ends correctly.

(3) Install the cover back on.

NOTE: When the batteries are removed, the

remote controller erases all programming. After

inserting new batteries, the remote controller

must be reprogrammed.

Replacing batteries

CAUTIONS

Do not mix old and new batteries or batteries

of different types.

Do not leave the batteries in the remote

controller if it is not going to be used for 2 or

3 months.

Do not dispose batteries as unsorted

municipal waste. Collection of such waste

separately for special treatment is necessary.

The device could comply with local

and national regulations.

In Canada, it should comply with CAN ICES-3(B)/NMB-3(B).

In USA, this device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not approved by the party responsible for compliance could

void user s authority to operate the equipment.

NOTE: