Other

File E214180 Vol. 1 Sec. 16 Page 23 Issued: 2007-10-02
and Report New: 2011-08-26
ALTERNATE CONSTRUCTION - MODEL E(A)M720D## – FIGS. 16 & 17
General – Model E(A)M720D## employs the alternate construction as below.
Fig. 16 shows the front view with door open and Fig. 17 shows the left side
view of the unit with the enclosure removed.
1. Oven Lamp and Air Inlet Opening - A series of holes measuring 3.0 mm
diameter each, located in the cavity right side wall. Covers overall
area measuring approximately 76 mm by 55 mm. See Fig. 16 for details.
2. Ventilation Openings - A series of holes measuring 3.0 mm diameter each,
located in cavity left side wall (covering two areas, one measured
approximately overall 135 mm by 55 mm wide and the other one measured
approximately overall 77 mm by 33 mm wide) and top side wall (covering
two areas, one measured approximately overall 67 mm by 10 mm wide and
the other one measured approximately overall 77 mm by 7 mm wide). For
details, refer to Figs. 3C and 3D. See Fig. 17 for details.
3. Steel Air Duct – Steel. Measured 0.5 mm thick, overall 80 by 67 by
46 mm. Secured to Oven Cavity top side by integral steel tabs and a
screw.