Other
File E214180 Vol. 1 Sec. 16 Page 20A Issued: 2007-10-02
and Report Revised: 2015-05-14
10. Oven Cavity Thermostat - R/C (XAXP2/8), CHANGSHU XIN DU AN ELECTRIC CO
LTD, Type KSD1-110, rated 125 V, 15 A. (E186242, dated 1997-11-15)
temperature limiting type, calibrated to open at 110C, close at 0C.
Secured to upper part of oven and prevented from moving by screws. The
center of Oven Cavity Thermostat is located at the Cavity right side
edge and 66 mm from Rear Enclosure. Terminals of unit are insulated
upon connection of mating terminal.
Alternate – Same as above except Jiangsu Changheng (Group) Co., Model.
NO. KSD110LC rated 125 V, 15 A, calibrated to open at 110C, close at
0C.(E206735 2000-08-01)
Alternate – Same as above except, Nanhai Xicheng Tianpeng Electric Co
Ltd, Model KSD201/PPS or KSD201/EC, rated 125V, 15A, calibrated to open
at 110C, close at 0C, limiting type. (E202192, 2002-07-18).
Alternate – Same as above except the center of Oven Cavity Thermostat is
located at the Cavity right side edge and 151 mm from Rear Enclosure.
Alternate - Same as above except, Foshan Tianpeng Thermostats Co.,
Ltd(E202192), Model KSD201, rated 125V, 15A, limiting type.
Alternate - Same as above except R/C (XAPX2/8) FOSHAN LIANHEHUILONG
ELECTRICAL APPLIANCE CO LTD (E349305), Model KSD301, limiting type,
rated 125/250V, 16A.
11. Magnetron Thermostat Metal Support – (Optional; Employed when the
optional Magnetron Thermostat is employed) Steel, measured 45 mm by 38
mm by 5 mm height, 0.5 mm thick. Secured to Magnetron by a screw and an
integral tab. See Fig. 11C for 4 intended securement locations.
*12. Cooling Fan Air Guide – R/C (QMFZ2), rated minimum HB, 65C. Maintained
minimum 0.8 mm spacing to live parts. Measured 155 mm by 120 by 75 mm
and maintained minimum 0.8 mm spacing to live parts. Secured to Rear
Enclosure by integral tabs and screws.
**
13. Ventilation Openings - A series of openings measuring 3.0 mm diameter
each, covering area measured approximately overall 135 mm by 55 mm,
located in cavity left side walls, and no openings were provided in
cavity top side walls, see Fig. 11A for details.
14. Oven Lamp and Air Inlet Opening - A series of holes measuring 3.0 mm
diameter each, located in the cavity right side wall, covering area
measured approximately overall 55.5 mm by 47.5 mm.