Other
File E214180 Vol. 1 Sec. 16 Page 14 Issued: 2007-10-02
and Report Revised: 2016-04-13
REAR VIEW, MODEL EM720C##, E(A)M720C##-PM, E(A)M820C##-PM - FIG. 6 AND 6A
General - Fig. 6 shows the rear view of the Model EM720C##. Represents
all models unless otherwise indicated. Fig. 6A shows the rear view of the
Models E(A)M720C##-PM and E(A)M820C##-PM.
1. Rear Enclosure – Painted steel, 0.5 mm thick. Secured to oven cavity and
bottom enclosure by either riveting, spot-welding, or by screws.
Measures approximately 432 mm wide by 236 mm high. Provided with hole at
top of the rear enclosure for placement of strain relief.
2. Air Inlet Openings – 3 mm diameter openings, covering an overall area of
45 mm by 42 mm on the Rear Enclosure left side.
3. Air Inlet Openings – 5 mm diameter openings, covering an overall area of
153 mm by 82 mm on the Rear Enclosure left side. For details, refer to
figure.
4. Air outlet louvered openings - 9 openings each measured 28.7 mm by 6.3
mm.
5. Power Supply Cord Strain Relief - R/C (QMFZ2), Rated HB, 70C. Measures
overall 18 mm by 20 mm. Molded onto cord.
Alternate – (For Models E(A)M720C##-PM and E(A)M820C##-PM only) Same as
above except the location for securing Strain Relief shown as Fig. 6A.
6. Power Supply Cord and Plug – (Not for Model E(A)M820C##-PM) Listed,
flexible cord, Type SPT-2, 3-conductor jacketed, 16 or 18 AWG, rated 105
C and terminated in a three-prong grounding-type attachment plug.
Overall length of cord may vary from 1 m to 2.1 m, measured from base of
plug to point of entry into appliance. When external cord length is less
than 1.4 m, text shown in MARKINGS AND INSTRUCTIONS, is provided in the
user instruction manual.
Alternate - For cUL models, type SJT shall be used.
7. Markings - R/C (PGDQ2/8 or CSA certified), rated minimum 85C for the
surface of plated steel, adhesive backed label located on painted steel
surface of the rear enclosure. See the Section General for additional
details on the markings applied to the unit.
8. Nameplate - R/C (PGDQ2/8 or CSA certified), rated minimum 85C for
surface of plated steel, adhesive backed label located on painted steel
surface of the rear enclosure. Nameplate includes Listee's name or
trade name, model designation, serial number, electrical rating in volts
and watts or current, the word "Household," the word "Manufactured"
followed by month and year in which the appliance is manufactured. The
month is stated without abbreviation and the year is given as a
four-digit number. Location of manufacture (city and country) are
provided on CNL models.