Other

File E214180 Vol. 1 Sec. 16 Page 8 Issued: 2007-10-02
and Report Revised: 2015-01-05
TOP VIEW OF MODEL EM720C## WITHOUT COVER - FIG. 4
General - Shows top view of the unit with outer enclosure removed.
Represents all models unless otherwise indicated.
1. Oven Cavity Thermostat - R/C (XAXP2/8), CHANGSHU XIN DU AN ELECTRIC CO
LTD, Type KSD1-90, rated 125 V, 15 A. (E186242, dated 1997-11-15)
temperature limiting type, calibrated to open at 90 C. Secured to the
top of the cavity by screws. Terminals of unit are insulated upon
connection of mating terminal.
Alternate – Same as above except Jiangsu Changheng (Group) Co.,
Mode. NO. KSD90LC rated 125 V, 15 A.(E206735 2000-08-01)
Alterante – Same as above except, Nanhai Xicheng Tianpeng Electric Co
Ltd, Model KSD201/PPS or KSD201/EC, rated 125V, 15A, limiting type.
(E202192, 2002-07-18)
Alternate - Same as above except R/C (XAPX2/8), Honest-Well Co., Ltd.
(E192925), type T24A090 series, rated 125V, 15A, limiting type.
Alternate - Same as above except, Foshan Tianpeng Thermostats Co.,
Ltd(E202192), Model KSD201, rated 125V, 15A, limiting type.
Alternate - Same as above except R/C (XAPX2/8) FOSHAN LIANHEHUILONG ELECTRICAL
APPLIANCE CO LTD (E349305), Model KSD301, limiting type, rated 125/250V, 16A.
2. Tamper Resistant Screw – (Not Shown) Tamper resistant screws are star-
shaped head with a center pin for engaging tool, shank 7.5 mm long by
3.7 mm OD, at least two provided, each mounted on either side of the
back bottom enclosure, secured the Top and Side Enclosure, Rear
Enclosure and Bottom Enclosure. Radius of curved screw head is 0.5 mm
maximum. Provided with permanent label R/C (PGDQ2 / 8 or CSA
certified), rated minimum 100C for surface of plated steel, adhesive
backed label located on painted steel surface of the rear enclosure,
located adjacent to at least one tamper resistant screw. Label includes
the following: “WARNING - Risk of electric shock. Non-removable
fasteners are provided because of internal high voltages. Do not remove
fasteners.”
3. Noise Filter Printed Wiring Board - R/C (ZPMV2), rated V-0, 130 C,
suitable for direct support part, With the across the line capacitor,
line choke and fuse mounted on it. The 1.6 mm minimum spacing over the
surface and through the air is maintained on board. Secured to the
plastic support with two taps. 0.8 mm spacing is maintained between the
live parts of noise filter and fan motor air guide plastic.