Installation Guide

Back of dishwasher
Quick Connection Installation Guide
Parts provided
Connect the star-shaped connection of the inlet hose onto the inlet port on the back of dishwasher.
Connect the circular connection of the inlet hose onto the shorter male of the quick connect.
Connect the six-sided connection of the drain hose onto the drain port on the back of the dishwasher.
Connect the circular connection of the drain hose onto the longer male of the quick connect.
Attach the quick connect onto the faucet adapter by pulling down the locking collar on the quick connect.
Slowly open the hot water line and check for any sign of water leaks at all hose connections.
IMPORTANT: Once you open the water supply line, the inlet hose will be pressurized. If you want to
remove the quick connect from faucet adapter, please close the faucet first and then press the red
pressure relief button to relieve water pressure before taking off the quick connect.
Inlet Water Connection
Take the existing aerator off your faucet.
Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (Use Teflon tape to eliminate if necessary).
IMPORTANT: Please confirm whether the supplied adapter is suitable for your faucet tap. If not,
please contact your local plumbing supply center where adapter is available for purchase .
Power cord
Inlet port
Drain port
Inlet Hose
Faucet Adapter Quick Connect
Inlet port
connection
Quick connect
connection
Female threads
Male threads
Inlet hose connection
Locking
collar
Red pressure
relief button
Remove aerator
1
Screw adaptor
2
Drain port
lnlet port
Faucet Adapter
Quick Connect
3
4
7
8
1
2
3
4
5
6
Sealing ring
Aerator
Drain port
connection
Quick connect
connection
Drain Hose
5
6
7
8