Quick Installation Guide Realtek Driver Installation M0304322 Version2.
1 Hardware Installation Here are two methods to install the usb adapter 1. Please insert the usb adapter directly into the computer's USB port. 2. Connect the USB port of the computer through the USB extension cable base. (USB extension base is sold separately) Note: When using the desktop, it is recommended to use the USB extension cable base to connect the rear interface of the computer chassis.
1.Put the CD driver into the computer drive. 2.Open the driver folder and double click the installation file “Setup.exe”.Click "Next"to finish the installation. （Note：If the installation file is a compressed package, you need to extract it to install it.） REALTEK 11n USB Wireless LAN Software REALTEK 11n USB Wireless LAN Software The InstallShield Wizard will install REALTEK 11n USB Wirekess LAN Software on your computer. To continue,click Next. Back Next Cancel 3.
3 Network Connection Settings 1. Double-click the wireless network card management icon to open the network card client management software. 2.
4.
2.After switching to access point mode, the SSID displays the name of the computer, as shown below: REALTEK 11n USB Wireless LAN Utility Refresh（R） Mode（M） About（A） MyComputer General Advanced Statistics Realtek RTL SSID： BSSID：00:0D:B1:A2:0B:D1 Association Table AID MAC Address ICS Period of use Configuration Note: The default of the computer name is WiFiSSID. The default is no password. If you need to use the password and change the SSID, please see the following operations. 3.
4.Click "ICS" to select the network connected to your computer, click Application , as shown below: (Win7 system interface will be a bit different here, the setting method is the same) REALTEK 11n USB Wireless LAN Utility Refresh（R） Mode（M） About（A） MyComputer Realtek RTL General Advanced Statistics ICS Set up Internet connection sharing（ICS） ConnName Device name WiFi connection 4 11b/g Wireless LAN Mini PCI Express Adapter III Application 5.
Thank you for purchasing products. To protect your rights and interessts in after-sales service please read the following maintenance regulations.
Copyright Information +86 755 83790059 en.comfast.com.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
