Owner manual

I I . Handing Precautions

＊ To prevent the risk of electric shock, the power plug must be plugged into a matching outlet and

grounded in good condition.

＊ Never try to lift a load higher than the rated cap.

＊ Never hitch a ride on the hook, sling or load being moving.

＊ Chain hoist is not to be used for lifting or lowering people.

＊ Don’t work, walk or stand under an operating chain hoist.

＊ Always remain in control. Never neglect the chain hoist while actually hosting a load.

＊ While working, never stand under a lifting load or within the conveying area.

＊ Always look up when working around chain hoist, there is potential danger overhead.

＊ Never gravitate a load free.

＊ Be sure to lift a load vertically..

＊ Prior to starting of use, carry out the daily checking without fail, and after confirming the safety

of function.

＊ If having a counter rotation incurred, make sure to correct its rotation direction.

＊ Prior to lift. Make sure to have a precise performance of brake. If any malfunction of brake happened,

stop the operation immediately.

＊ When load suspended in air, it will not allow to be welding.

＊ Load chain with any remarkable wears and elongations shall be removed or replaced immediately.

＊ Stop the operation if there is any queer noise or vibration in the gear box to be happened.

＊ Do not connect the load chain with the grounding of welding machine.

＊ While welding, do not have any contact with the welding objects because of having spark.

＊ Do not pull the switch.

＊ Do not over the rated intermittent period.

＊ Do not operate beyond the limits of the load chain travel

＊ Be sure to fix a load chain in the center of load hook.

＊ Be sure to stop operation immediately when the load chain becomes fully slackened.

＊ Avoid catching the hook or lifting a load on a fixed obstruction.

＊ Always leave the pendant switch positioned immediately after use.

＊ Make sure that the load being lifting is well balanced and secured before starting.

＊ Avoid water splashes on the pendant switch and electrical circuits.

＊ Never wrap the load with the load chain.

＊ A power cut-off switch located below the house lights red, please stop the hoisting immediately.

Please reset the switch by hand after reducing a load by manual。

＊ The hoist is equipped an up mechanical torque limit device, it activates when over-riding

operation found. It does not allow to activate for more than 6 seconds, otherwise it may damage

the hoist endurance.