User manual

8
the same number.
Chapter Three: Description of Operation System
3.1 Turn ON / OFF
Confirm that AC voltage accessible matches with DVR. Ensure that the DVR power outlet connect
with a good middle ground grounding. After switching power, the device started, 【POWER】 light is
on. Turn into system, if the panel status light flashing, it's normal conditions.
3.2 Preview
After device start, preview interface can be seen immediately. In the preview interface you can see the
system date, time, channel name. Press corresponding number key of panel or click the left mouse
button, user can preview the single channel. Press "QUAD" key in the panel or click the left mouse
button, to return to a multi-interface monitoring state.
3.3 Menu operation instructions
3.3.1 Menu
【MENU】,enter the device's main menu interface. 【PLAY】 shortcut keys for playback interface.
【REC】shortcut keys for manual recording.【PTZ】shortcut keys for PTZ control.
Note: Default password is empty, click "enter" can into menu directly.
3.3.2 Menu composition
Menu component units as following:
（1） Check box: two kinds of status available, "√" means valid, "□" means invalid , direction key:
【↑】【↓】【←】【--->】,enter key【 】. Also, click the left mouse button to choose.
For example: "channel" and "video mode" check box in the video research.
（2） Selection box: select the target content according to the drop-down box options. Use
【↑】, 【↓】 key or click the left mouse button to select.
For example: "channel" and "code stream" in the encode setup menu
（3） List Box: Displays the research information in the list, you can try one option for operation
For example: Press【 】 button in the video backup file. or the left mouse button.
（4）Edit box: Enter the name into edit box
For example: in the setup menu, you could input numbers, English letters, punctuation and so
on in the "channel" edit box.
a) use panel key 【↑】【↓】【←】, 【→】or move the mouse to edit box , press " " key
or click the left mouse button, then enter keyboard appears, select the desired input target
characters through the arrow keys or click the left mouse button.