Instruction manual

H264 Digital Video Recorder art. 49807

FACTORY RESET

To reset the unit, you will need a straightened paperclip:

Turn the DVR off.  Poke the straightened paperclip in the unlabeled hole to the right of the Alarm

Output connector, and turn the DVR on.  Hold the switch until the DVR turns on and live monitoring

screen appears.  Release the reset switch. All of the DVR’s settings are now at the original settings

it had when it left the factory.

CAUTION: When using the Factory Reset, you will lose any settings you have made.

FRONT PANEL CONTROLS

① HDD LED: The LED flickers when the DVR is recording or searching video on the hard disk drive.

② ALARM LED: The LED is lit when alarm output or internal buzzer is activated.

③ Camera Buttons (1 – 4): Pressing the button displays the selected camera in full screen. In PTZ mode,

pressing the 1 or 2 button zooms in or out, and the 3 or 4 button focuses near or far.

④ Arrow Buttons: Pressing the button controls playback of recorded video in playback or searching mode.

Pressing the button moves to another item or changes a selected number value in Main Setup menu.

Pressing the button pans or tilts a PTZ camera in PTZ mode.

⑤ Play/Pause Button ( ): Pressing the buttons freezes the current screen in the live monitoring mode.

In the playback or search mode, pressing the button plays back images at regular speed or pauses playing

video. In the Main Setup menu, pressing the button selects an item or completes the entry you have

made. The blue LED surrounding the button is lit while the unit is turned on.

⑥ USB Port: Connecting the USB device allows you to upgrade the software, to copy video clips and to

import or export DVR settings.

⑦ PLAYBACK Button: Pressing the button in the live monitoring mode enters the playback mode and

pressing the button again exits the playback mode. It also loads the PTZ preset in the PTZ mode. In

the playback mode, pressing and holding the button for two seconds or longer starts copying video clips.

Chapter 2 – Operation  Searching, Clip Copy for details.

⑧ DISPLAY Button: Pressing the button toggles screen mode between quad and sequence. When the

DVR does not detect a VGA monitor automatically, pressing and holding the button for 5 seconds or

longer will toggle the video output between Video Out and VGA out. During clip copy, you cannot

switch the video output mode.

⑨ PTZ/ZOOM Button: Pressing the button toggles PTZ mode and zoom mode. In the live monitoring

mode, pressing the button enters PTZ mode. In the PTZ mode, pressing the button enters zoom mode.

Pressing the button again exits the zoom mode.

⑩ MENU Button: Pressing the button launches or closes the Main Setup menu in the live monitoring or

recording mode, Search Menu in playback or searching mode, or PTZ menu in PTZ mode.