Instruction manual

User’s Manual
16
 No.: Select to set the alarm-in detection for entire alarm-in devices
(No.) or an individual device.
 Title: Choose to change the name of all or each alarm-in device.
 Type: Set up each input as NO (Normally open) or NC (Normally
closed).
 Actions: Choose to set up actions when the DVR senses an input
on the alarm input connectors.
The DVR can notify you when it
senses an input on the alarm input connectors by sounding an alarm
or beep or by sending an e-mail.
– Alarm-Out: Select to associate the input detected in the alarm-in
connectors with alarm-out signals.
– Notify: Select to send an e-mail to the address set during
NETWORK – Mail setup.
NETWORK
 Remote Watch: Set up the transfer speed and quality.
– bps/ips: Set up the transfer speed, and choose the unit of measure
for the transfer speed between: bps (byte per second) and ips
(image per second).
– Quality: Choose the quality for transferred image.
 Network Bandwidth Limit: Set up the desired maximum
bandwidth. When limiting the network bandwidth, the frame rate
might decrease to lower than the frame rate set in the RECORD
setup screen.
 Use WebGuard Service: Select to use the WebGuard service. See Appendix – WebGuard for details.
 Port: Set up the port number for WebGuard program access.
 Use SSL for Transferring Data: Select to use the SSL (Secure Socket Layer) function. You can enhance
the security of data except video transmitted to the PC running remote software program by using the
SSL protocol. When using the SSL function, the DVR cannot be connected with a remote program or
a network keyboard which does not support the SSL function.
NOTES:
 The higher Quality settings require higher Transfer Speed settings. The transfer speed you set is the
maximum speed. Depending on the network environment, this speed may not be achieved.
 The local recording speed might be affected by various network bandwidth (Transfer Speed) conditions.
 The Remote connection will be disconnected temporarily after changing the SSL settings.
 This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/)