Instruction manual

H264 Digital Video Recorder art. 49807

NOTE: When set to the H.264 codec, the DVR can record more images by compressing more effectively

than using the MPEG-4 codec. However, the recording speed might decrease depending on the display

option and DVR’s operation mode.

 Selecting the H.264 codec and enabling the VGA Enhancement function will cause the recording speed

to be decreased by half. Refer to the System section in this chapter for setting up the VGA Enhancement

function.

 The maximum recording and playback speed when using the H.264 codec is as follows.

When the DVR is in the Recording Mode only

Disable VGA Enhancement Enable VGA Enhancement

120 ips (100 ips PAL) 60 ips (50 ips PAL)

When the DVR is in the Recording mode and Playback mode at the same time

Recording Speed Playback Speed

60 ips (50 ips PAL) 120 ips (100 ips PAL)

EVENT

 No.: Select to set the video motion detection for entire cameras

(No.) or an individual camera.

 Sensitivity: Adjust the DVR’s sensitivity to motion

for Daytime

and Nighttime independently. Smaller numbers provides lesser

sensitivity. (1: the least sensitive, 5: the most sensitive)

 Zone: Define the area of the image where you want to detect motion; e.g., a doorway, and the Motion

Detection Zone screen is laid over the video for the selected camera. You can set up motion detection

zones by selecting or clearing blocks. You can select or clear four individual blocks in a group at a time,

and individual blocks within the group are selected or cleared by using the camera buttons. Pressing the

(Play/Pause) button displays the menu screen, and each item in the menu has the following functions;

– Select/Select All: Select to activate highlighted blocks/all blocks to detect motion.

– Clear/Clear All: Select to deactivate highlighted blocks/all blocks not to detect motion.

– Reverse/Reverse All: Select to activate inactive highlighted blocks/all inactive blocks and to deactivate

active highlighted blocks/all active blocks.

– OK/Cancel: Select to accept changes and closes Zone setup/Exits Zone setup without saving changes.

 Min. Blocks: Adjust the minimum number of detection blocks that must be activated to trigger a motion

alarm. Adjust the minimum number of detection blocks for Daytime and Nighttime independently.

 Actions: Choose to set up actions when a motion is detected in a camera channel. The DVR can notify

you when a motion is detected in a camera channel by sounding an alarm or beep or by sending an e-mail.

– Alarm-Out: Select to associate the motion detected in the camera with alarm-out signals.

– Notify: Select to send an e-mail to the address set during NETWORK – Mail setup.

 Motion Ignoring Interval: Adjust the motion ignoring dwell time. You can control excessive event

logging and remote notification of motions detected after the motion dwell time by adjusting the motion

ignoring dwell intervals. The DVR will not log and notify motion events occurred during the preset

interval range. The recording for motion events will not be affected by the Motion Ignoring function.

 Daytime Setup…: Set up the daytime range. The DVR will consider the remaining time range as the

nighttime.