Operating instructions

44
 Data Bit – press +/- buttons to change the value.
 Stop Bit – press +/- buttons to change the value.
 Parity – (Odd, Even, or None). Press +/- buttons to change the value.
 DVR/Camera ID – for PTZ => the device ID for this digital video/audio recorder must not
conflict with the other devices connected in the same control port. Press +/- buttons to change
the ID.
6.10 Network Setup
In Setup Menu display, press ▲▼ to change the highlighted option to Network and then press
ENTER to call up Network Setup as shown.
The Network Setup allows the administrator to setup all Ethernet network related parameters.
Please check with your network administrator to set these parameters correctly. For most home users,
the typical configuration would connect the DVR to a router to the internet. In those cases, please
see your router user manual for details on how to port forward data and controls to/from the router to
the DVR. In addition, most home users will have dynamic IP addressing. Please use a dynamic DNS
service, such as http://www.dyndns.com, to access your router and DVR from the internet.
The general operations are as below:
 ▲▼◄►
Press these buttons to select the items.
 ESC
Press this button to escape from this screen and return to Setup Menu display. If the Save dialog
is shown, press ENTER to exit and save, ESC to exit without saving.
Following is a brief description for each item and its specific operations:
 Net Type – Static IP, PPPoE or DHCP. DHCP can only be used for intranet (LAN) access, while
Static IP and PPPoE can be used for both internet & intranet access. Press +/- buttons to change
the Net Type.