Operating instructions

 Auto Overwrite – automatic overwrite of the recorded video/audio from HDD#1 when the

Alarm/Normal Record disk drive capacity reaches the end of the last HDD. If Auto Overwrite is

disabled and the Alarm/Normal Record disk drive capacity reaches the end, the system will not

overwrite the recorded video/audio and hence not record Alarm/Normal video/audio, until the

user presses the Alarm Reset button. Press ENTER or +/- to check/uncheck this item. The

default setting is “ˇ

ˇˇ

ˇ” - checked.

 HDD Full Action – actions when Alarm/Normal Record disk drive capacity reaches the end of

the last HDD. Press ENTER or +/- to check/uncheck this item. The default setting is “

ˇˇ

” -

checked.

 Duration – response duration to define at most how long (in seconds) the Alarm Out relay and

the Buzzer will keep being triggered after the corresponding partition, Alarm Record or Normal

Record, is full. Press

+/-

buttons to adjust the value (3-60 seconds, discrete).

 Alarm Out – to define which Alarm Output will be triggered when the corresponding partition,

Alarm Record or Normal Record, is full. Press +/- buttons to select none (N/A) or one of the

Alarm Outputs (1-2).

 Buzzer – to activate the internal Buzzer or not when the corresponding partition, Alarm Record

or Normal Record, is full. Press ENTER or +/- to check/uncheck this item. The default setting is

“

ˇˇ

” - checked.

 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this item. The default

setting is “ˇ

ˇˇ

ˇ” - checked.

 E-mail – to send the event e-mail to remote station or not. The e-mail will be sent to the

predefined receivers when the event is triggered. Press ENTER or +/- to check/uncheck this item.

The default setting is “–

––

–” - unchecked.

6.6.1 HDD Format/Clear

In HDD Setup display, press MODE to call up HDD Format/Clear screen as shown.

The HDD must be formatted before it can be used to record video/audio. The HDD

Format/Clear screen allows the administrator to format and/or clear each HDD and set the size for

Alarm Record partition and Normal Record partition for each HDD. Please use only HDD with

maximum storage size as 500GB set as MASTER and make sure there’s no remote user before

formatting the HDD.