Operating instructions
29
Motion Detection – whether the motion detection of this camera is enabled or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ
ˇˇ
ˇ” - checked.
Motion Settings.. – used to setup the motion settings for this camera. Press ENTER in Settings..
to call up Motion Setup display for the camera. Please refer to Section 6.2.2 for the details.
Covert – covert or not. If the camera is covert, the video of this camera can only be seen if the
user has logged in as Administrator. Press
ENTER
or
+/-
to check/uncheck this item. The default
setting is “–
––
–” - unchecked.
Call By Event – whether to switch the call monitor to the video of this camera if certain event
occurs for this camera. There are 4 options, including Off, Motion, Alarm, Both (Motion &
Alarm). Press +/- buttons to select one.
Dwell Time – the dwell time if Call By Event is set to Motion, Alarm, or Both. Press +/-
buttons to adjust the value (3-60 seconds, discrete).
Audio – the AUDIO IN corresponding to this camera. If selected, the audio data for the
selected AUDIO IN will be recorded with the video data for this camera. Press +/- buttons to
select none (N/A) or the AUDIO INput. The default setting is “N/A”.
Record Quality – the record quality for this camera. Press +/- buttons to select the value (1-9,
with 1 the lowest (rough) quality, 9 the highest (fine) quality).
Event Record IPS – the IPS (Images Per Second) for this camera if certain event (Motion,
Alarm) occurs for this camera. This camera will be recorded at this rate for Post-record time
since the event occurs. (Please refer to the following sections for Post-record time). Press +/-
buttons to select the value (0 – 25 (PAL) / 30 (NTSC), discrete).
Pre-record IPS – the Pre-record IPS for this camera if certain event (Video Loss, Motion, Alarm)
occurs for this camera. This camera is recorded at this rate for Pre-record time before the event
occurs. (Please refer to the following sections for Pre-record time). Press
+/-
buttons to select the
value (0 – to Event Record IPS for this camera, discrete). Please note that the total Event
Record IPS / Pre-record IPS should not exceed the system recording capacity (NTSC: 120/CIF,
60/Half-D1, 30/Full-D1; PAL: 100/CIF, 50/Half-D1, 25/Full-D1) or the system will lower the
actual rate automatically at recording.
Normal Record IPS – the normal record IPS for this camera. This camera will be recorded at
this rate if no event occurs. Press +/- buttons to select the value (0 – to Pre-record IPS for this
camera, discrete).