Operating instructions

Operation Manual – Art. 80153 (Version 1.1.6)
26
Mouse function:
Left Mouse: Click the icon “►” or “◄” to adjust value.
Right Mouse: Previous.
Preset setup:
User must set preset at first. The address, protocol and baud rate of DVR is consistent with Dome’s. You
can make use buttons to control dome and save the preset.
If user wants to call preset, user can modify the value of preset to come true. Press「Select」button to finish
the order of “call preset”.
User can perform auto scan when he saves the presets within cruise locus. Then he needs to press
「Select」button to finish the order of “auto scan”, the dome will run all along unless user presses「STOP」
button to stop it.
PTZ Mode:
Enter into PTZ mode and hold a right mouse
click button, there will be a piece of message
on the screen (right figure).
Icon function:
“▲▼►◄”: Move the dome upwards/downwards\leftwards and rightwards.
“■”: Stop the dome running.
“ 、 ”: Focus.
“ 、 ”: Zoom.
“ ”: Auto scan.
“ ”: Previous.
Attention:
User can start-up automatic scout in “PTZ SETUP” menu or PTZ mode. It doesn’t stop when user exits. If
user wants to stop scouting, press 「STOP」button in PTZ mode.
During live view, user can press「PTZ」button to enter PTZ mode and then user can operate to control the
dome according to the method of above paragraphs.
5.6.8 F/W UPGRADE
This menu is for firmware upgrade of DVR system through USB host (USB memory stick) connection, you
can simply upgrade the system once you connect the USB memory stick that contains a firmware file.
CAUTION: 1. Do not turn off the system while the system is upgrading. Otherwise, it will cause the
breakdown of the system that needs a special recovery process.
2. If you don’t install a HDD in the DVR, the system can’t be upgrade.
3. Before the system is upgrade, you must stop recording.