Operating instructions

Operation Manual – Art. 80153 (Version 1.1.6)
14
* Only the corresponding channel will record when a sensor trips, (e.g. sensor one corresponds with
channel one).
4.6 Alarm Connection
The DVR has an internal switch for sounding alarm. The switch is normally open, but when the sensor is
triggered, the alarm is activated as well. The circuitry is as follows.
First, connect the alarm power lines to the alarm switch terminal. Second, connect the alarm power lines to
the appropriate power source.
4.7 Mouse Connection
Connect PS/2 mouse with the port below on the system, PS/2 mouse must be connected to DVR before
startup system.
4.8 DVR Power Connection
Connect a DVR power adapter to the adapter jack at the rear panel of DVR unit.
Turn the power switch on. It will boot up the system.
(1) Normal-Close (2) Normal-Open (3) Normal Close & Open
DVR Rear Panel
ALARM