User`s guide

11.2 Interpreting The Trouble Symptoms
Should your digital wireless telephone fail to operate properly,
review the following list of symptoms and causes for help.
Symptom Possible Cause
Charge light will not turn on when
you place handset in base unit
–Be sure AC adapter is plugged into
base unit and wall socket. Be sure
handset is properly seated in base
unit cradle
–Be sure nickel-cadmium battery
pack is properly installed on hand
set
–Be sure that the charging contacts
on the handset and base unit are
clean
Frequent interruptions in conversa-
tions
–Be sure base unit antenna is vertical
–Move handset closer to base unit
–Locate base unit at a greater height
Hear warning tone and see NO SER-
VICE message in display
–Move handset closer to base unit
Handset does not ring
–Weak battery (replace with fresh
battery
pack or charge handset for 8–10
hours)*
–Check ringer alert setting—may be
set for ringer off without optional
vibrator alert installed
–Be sure base unit antenna is fully
vertical
–Move handset closer to base unit
Error Tone
–May occur when incorrect buttons
are pressed during speed dial
programming. For example,, if a
button has a line assigned to it,, it is
not available as a programmable
button and an error tone sounds if it
is pressed during programming.
Scrambled display
No link
Feature access problems
–Reset power
Display shows No Comm.
–base unit cannot make contact with
telephone system. Check line cord.
Troubleshooting Your Telephone
82