User`s guide

10.6 Charging the Handset’s Battery Pack

You must fully charge the rechargeable nickel-cadmium battery

pack before using your digital wireless telephone for the first

time. This means that you should allow the unit to charge with

out interruption for 8–10 hours.

If you do not intend to use the handset for more than a day, ei

ther store the handset on the charger or take the battery pack off

the handset to avoid draining the battery too low.

1. Place the handset on the base unit.

NOTE: The unique design of your digital wireless telephone allows you

to place the handset on the base unit either face down or face

up, with or without the belt clip attached. The battery pack in

the handset automatically recharges in either position.

Please note that the telephone’s buttons are inoperative while

the handset is on the charger.

Make sure the CHARGE LED turns on. If the CHARGE

LED does not turn on, check to see that the AC adapter is

plugged in, and that the handset is making good contact with

the base unit.

NOTE: Occasionally, use your handset until the display shows the low

battery indication. As soon as you see this indication, discon-

tinue further use, and recharge or replace the battery pack.

Installing The Digital Wireless Telephone

CHARGE POW ERBATT

CHARGE

EXP95BFT

Scout

900