Specifications

Programming Reference Guide
GCA3A39-877, Rev 5, Issue 9/01 Page 2 Printed in the USA
Installing the VMMI Program and Help Software
The VMMI software is your entry to the communications system. Before you can log in to
the system, you must first load the VMMI program and help software on the computer hard
drive. When installing the VMMI software, the PC does not need to be connected to the
system equipment.
Loading VMMI with Windows 3.1
1. Turn on the PC and run the Windows software.
2. Insert the VMMI program disk in the computer diskette drive.
3. From the Windows Program Manager screen, select the File pull-down menu.
4. From the File pull-down menu, click Run.
5. At the Run window, type A:\setup, and click OK.
6. The install window gives a default file location to install the program; however, you can
enter a different file location if you wish. Click OK to install the program in the default
file location, or enter a different file location and click OK.
7. The install window gives a default location of the VMMI program disk; however, if you
have installed the disk in a different drive, enter that location. Click OK to use the
default location, or enter a new location and click OK. The status window appears on the
screen and the program loads automatically.
8. When the status window shows the install to be complete, click OK to complete the
install.
The install program creates a program group and a VMMI icon in the Program Manager
screen.
Loading VMMI with Windows 95
1. Turn on the PC and run the Windows software.
2. Insert the VMMI program disk in the computer diskette drive.
3. From the Windows 95 screen, click Start, and then click Run.
4. At the prompt window, type A:\setup, and click OK.
5. Follow the onscreen instructions and add information as required to any additional
prompt lines that may appear.