Specifications

VMMI Programming Exercises
GCA39-082 Rev 2, Issue 9/01 Page 12 Printed in the USA
VMMI Discussion Points
This segment discusses:
• Group Intercoms / Add/Remove Item
• Stations / General / Group Intercom Access and Intercom Hunt List
• Stations / Button Mapping
Exercise Setup
Task Comment
1. Add group intercoms in VMMI:
• Select Add/Remove Intercoms in Group
Intercoms.
This step is not required if master clear Mode 1 or 2
was selected.
2. Provide four additional intercom paths to
extension 1002:
• Select the Intercom Hunt List in Station
Programming/General.
• Use 4101, 4102, 4103, and 4104.
• Add the personal and four group intercoms.
Add the personal intercom in the list first.
See the screen shots on the following pages for
items to enter in your database.
3. Provide access to these four group intercoms to
extension 1003:
• Select Group Intercom Access in Station
Programming/General.
• Add the four group intercoms: 4101, 4102,
4103, and 4104.
See the screen shots on the following pages for
items to enter in your database.
4. Remove the line appearances, except for the
E&M Tie Lines, from 1002 and 1003 in Button
Mapping. Button map the 4 group intercoms to
1002 and 1003 starting at LI on each phone.
See the screen shots on the following pages for
items to enter in your database.
5. Add the first 4 Loop Start lines to Line Group 1.
From the Programming menu choose the Line
Menu, and then choose Line Groups. In the Group
Members column, type in 1-4 and press Enter.
Apply the changes.
6. Button Map LNG1 on 1002 and 1003 on button
6.