Specifications

VMMI Programming Exercises
GCA39-082 Rev 2, Issue 9/01 Page 18 Printed in the USA
VMMI Discussion Points
This segment discusses:
• Lines / Line Type Specific DID / DNIS Block.
• Line menu / DID Block Options.
• Line menu / DID Translation Table (for a new table you must use Add / Remove Item).
Exercise Setup
Task Comments
1. Program a DID Block using the programming steps
listed below.
When programming, insert the data shown in the VMMI
screen shots below.
2. Select the Programming pull-down menu.
• Select the Line Menu option.
• Select the DID Block Options option.
Note the upper right of your screen identifies which block
you are programming. You can use the right/left arrow
keys in the tool bar to change the selection or browse.
3. Select the Programming pull-down menu
• Select the Line Menu option.
• Select the Translation Table option.
To begin a table click on Edit, Add Item and in the box
fill in the appropriate information.
4. Save the database.