Specifications

FX II Hardware Introduction
GCA39-824 Rev 2, Issue 4/02 Page 6 Printed in the USA
• The board includes:
* 8 or 16-built-in DTMF receivers (based on board type)
* 4 Com ports
* 3 Option slots: Can support the following option cards:
* 1 T-1 Synchronization card (Maximum)
* 1 Communication card (Maximum)
* 3 DTMF receivers (Maximum)
• Primary and secondary strapping for T-1 Synchronization card takes place on the FXAUX2-8
or FXAUX2-16.
FXINT- MAUXII Auxiliary Board
• The FX II main cabinet auxiliary board allows the customer a host of telephony configuration
and features options. This board only installs in the main cabinet, and is not needed in any
expansion cabinet.
• The FXINT-MAUXII is the only FX II auxiliary board that is required for expansion to
additional cabinets.
• The board also contains additional built-in features for supporting the system, such as:
* 8 DTMF receivers
* 4 Com ports (non-dedicated and programmable to 19,200)
* 2 dedicated slots for SCSI / Fiber expansion
* 1 Option card slot: Can take 1 DTMF receiver card or 1 Synchronization card. This slot
cannot support a Com card.
As with the FXAUX2-08/16 board, Primary and Secondary strapping for T-1 Synchronization
card takes place FXINT-MAUXII.