Specifications

Understanding Available Resources
GCA39-827 Rev 1, Issue 9/01 Page 8 Printed in the USA
dxp00023.pdf 04/26/01
Question: On my networking site, the nodes are not passing outbound caller ID information over
a PRI when accessing a line in the hub. What is causing this?
dxp00024.pdf 04/26/01
Question: I have CFOS set on my system with PRI lines. Intercom calls will CFOS, but not lines
transferred or directly ringing to this station. What am I missing in my programming?
dxp00025.pdf 04/26/01
Question: What is the proper procedure for resetting my DXP/DXP Plus modem?
fq-dxp00026.pdf 05/16/01
Question: In VMMI 180, I go to program my DID block or my Group Intercoms and get a blank
screen. How can I program by DID block or Group Intercoms?
fq-dxp00027.pdf 05/16/01
Question: I am using Toll/ARS on my 180 feature 16A system. Every time I dial out I get
"invalid number" on my display. This is happening on both networked systems, and stand alone
switches. What is causing this?
fq-dxp00028.pdf 05/16/01
Question: I am setting up a networking system using 16A VMMI. I've checked all of my
programming, I have all of the extension numbers provisioned, but I still cannot intercom across
the network. What is missing in programming?
fq-dxp00029.pdf 05/16/01
Question: I have installed 180 Imprint on my Windows 95/98 PC and I can't get it to work. What
should I do?
fq-dxp00030.pdf 05/16/01
Question: Whenever a caller makes an outbound call, they hear a double beep either on their
handset or through their speaker, after about 5-10 seconds. What is causing this?
fq-dxp00031.pdf 05/30/01
Question: Does the Comdial DXP/DXP Plus/FX Family support hook flash capabilities on a T-1
circuit?
fq-dxp00032.pdf 05/30/01