Specifications

System Operation
IMI 66-097
Programming The Station Speed Dial
Station speed dial numbers can be stored by the
station user for later redial. The storage locations are
keypad digits 0 through 9 on the station. Before
attempting to program, decide on the following kerns:
(1) the number or feature to be stored, (2) which
storage location will be used (0 - 9), (3) the circuit that
the call will go over (individual line or Intercom).
To program numbers,
press ITCM % * 2,
dial a memory location (0 through 9),
press specific line button or ITCM button to store
line or intercom preselection if desired (optional),
dial the number sequence to be stored. (up to 15
digits can be stored and valid digits include 0 - 9, #,
and *).
l To store a pause lf requlred, press HOLD.
l To store a hookflash lf required, press TAP.
Example: Store a telephone number under
location 0. The sample number is
1(804)555-2222. Program R as follows:
lTCM,*,~,2,O,Lhw Button,l,8,0,4,5,5,5,2, 2, 2,2.
To store another number,
l press TRANSICONF,
l press next speed dial location,
l make line pre-selectbn if desired,
l dial number for storage,
l repeat this procedure until all desired numbers are
stored.
To end statlon speed dial programming,
l press MNTR (SPKR).
Programming The Direct StatIon
Selection/Busy Lamp Field (DSWBLF)
One-button intercom calling with visual indication of
telephone status can be programmed at telephone
buttons not assigned to lines. The DSS/BLF console
buttons are fixed by the system for DSS/BLF operation
beginning with station 10 and ending with the
maximum station number In the system.
To program DSS,
0 press ITCM * * 3,
l press button to be programmed as DSS button,
l dial extension number,
l repeat last two steps for all desired extension
numbers.
To end DSS programmlng,
l press MNTR (SPKR).
NOTE: An autodial number can also be programmed
as a secondary function at every DSS/BL F
memory location. See Automatic Dialing
instructions forprogramming details.
Programming The Automatic Redial
Button
The system will allow the last previously dialed
number to be automatically and repeatedly redialed for-
approximately ten minutes. A button must be
programmed to provide this feature.
To program a programmable button for use as an
automatic redlal button,
l presstTCM +*I,
l press desired programmable button,
0 press #,
l press MNTR (SPKR).
5-9