Specifications

Programming Instructions
IMI 66-097
SECTION 2
CLASS OF SERVICE PROGRAMMING
Class of service programmlng is usually performed
by the system installer. Class of service programming
procedures provide the means for programming all of
the system variables including the -master clear. The
installer may elect to program only the line attributes
and allow the remainder of the system variables to
remain set to their default values so that the system.
administrator can re-program just the features that the
site requires. Perform class of service programming as
shown below.
System admlnlstratlon programmlng is performed
by on-site personnel to change all system variables,
except master clear and line attributes, to snatch stte
requirements.
@ Enter the base level programming mode.
Press: ITCM +k # 7 4 6 +k
(Press: ITCM + # 2 3 6 +k for System
Admlnlstratlon programmlng)
&
TYPICAL FEATURE PROGRAMMING SEQUENCE
later redi it l utomatfcalty
stores a
retrieve it. E%ludve
LED ON =
ENABL
pkkupcanbedi by
T
programming actio .
I
Press t for next feature.
Dial a feature code to select a
programming
A current program setting is indicated by a lighted
LED next to the applicable programming button.
When a toggle (ON/OFF) action is provided by a
single button, the lighted LED indicates when the